Here is the output. Looks exactly like another user (Andrew Donnely) whom you are helping. Note I already opened a ticket with help desk. (Ticket 1068). U-Boot 1.1.4 (Aug 28 2015 - 16:51:26) AP121 (ar9331) U-boot DRAM: 64 MB Top of RAM usable for U-Boot at: 84000000 Reserving 140k for U-Boot at: 83fdc000 Reserving 192k for malloc() at: 83fac000 Reserving 44 Bytes for Board Info at: 83fabfd4 Reserving 36 Bytes for Global Data at: 83fabfb0 Reserving 128k for boot params() at: 83f8bfb0 Stack Pointer at: 83f8bf98 Now running in RAM - U-Boot at: 83fdc000 Flash Manuf Id 0xef, DeviceId0 0x40, DeviceId1 0x18 flash size 16777216, sector count = 256 Flash: 16 MB Using default environment In: serial Out: serial Err: serial Net: ag7240_enet_initialize... Fetching MAC Address from 0x83ff4068 Fetching MAC Address from 0x83ff4068 : cfg1 0x5 cfg2 0x7114 eth0: 00:03:7f:11:40:00 eth0 up : cfg1 0xf cfg2 0x7214 eth1: 00:03:7f:11:40:01 athrs26_reg_init_lan ATHRS26: resetting s26 ATHRS26: s26 reset done eth1 up eth0, eth1 Hit any key to stop autoboot: 0 ar7240>help reset - Perform RESET of the CPU ? - alias for 'help' boot - boot default, i.e., run 'bootcmd' bootd - boot default, i.e., run 'bootcmd' bootm - boot application image from memory cp - memory copy erase - erase FLASH memory help - print online help md - memory display mm - memory modify (auto-incrementing) mtest - simple RAM test mw - memory write (fill) nm - memory modify (constant address) ping - send ICMP ECHO_REQUEST to network host printenv- print environment variables progmac - Set ethernet MAC addresses run - run commands in an environment variable setenv - set environment variables tftpboot- boot image via network using TFTP protocol version - print monitor version ar7240>